Showing posts with label 120827. Show all posts
Showing posts with label 120827. Show all posts

Tuesday, June 11, 2019

2017 Infiniti G37 Sedan V6-3.7L Diagnostic and Repair Information # 09-011A Date: 120827

2017 Infiniti G37 Sedan V6-3.7L Diagnostic and Repair Information # 09-011A Date: 120827



Wipers/Washers - Intermittent Wiper Operation Information



Classification: EL09-008A



Reference: ITB09-011A



Date: August 27, 2012



INTERMITTENT WIPER OPERATION



This bulletin has been amended to apply to all vehicles with Intermittent Rain Sensing Wipers.



Page 69



APPLIED VEHICLES:



Infiniti vehicles with Intermittent Rain Sensing Wipers



SERVICE INFORMATION



Vehicle may be equipped with the Rain-Sensing Auto Wiper system.



With this system:



> A rain sensor is located on the windshield, if equipped.



> When the wiper lever is pushed down to the intermittent (INT) position, the wipers will operate when the rain sensor detects rain.



> May only make a single stroke unless rain is detected directly above the sensor.



NOTE:



The wipers may operate unexpectedly when dirt, fingerprints, oil film, or insects are located on or around the sensor, or when exhaust gas or



moisture affect the rain sensor.



EXAMPLES OF RAIN SENSORS



If a customer states the wipers do not work when the wiper lever is pushed down to the intermittent (INT) position, make sure the customer is



familiar with the above information.



^ You can demonstrate the operation of the system by pushing the wiper lever down to the intermittent (INT) position and spraying/sprinkling water



over the rain sensor.



NOTE:



If a wiper-operation incident does occur, refer to the applicable Electronic Service Manual (ESM) for further diagnostic assistance.

Tuesday, February 12, 2019

2017 Infiniti G37 Sedan V6-3.7L Diagnostic and Repair Information # 10-038 Date: 100621

Engine Controls - ECM Programming Interruption Recovery
Classification: EC10-016
Reference: ITB10-038
Date: June 21, 2010
ECM REPROGRAM INTERRUPTION RECOVERY PROCEDURE
SERVICE INFORMATION
A complete step-by-step General Procedure for CONSULT-III (C-III) ECM Reprogram Interruption Recovery is now available in this bulletin as a
attachment.
While performing ECM (Engine Control Module) reprogramming, the reprogramming may stop (become interrupted) before it is 100% complete.
One of two messages may appear:
^ The VI probe is disconnected on USB, please check the connection of the probe.
^ Reprogramming fail, "Error code 0".
In many cases, reprogramming recovery is possible and the ECM may not need to be replaced if the complete ECM part number has been registered
into the ECM before reprogramming stopped.
NOTE:
ECM is referred to as ECU in C-III.
The ECM Reprogram Interruption Recovery General Procedure applies to Technical Service Bulletins that include ECM reprogramming published
in April 2010 and later.
IMPORTANT: BEFORE STARTING REPROGRAMMING
^ Connect a battery charger to the vehicle battery.
^ Be sure to turn OFF all vehicle electrical loads.
^ For ECM reprogramming, the C-III MUST be connected to the VI using the USB cable.
^ Be sure to connect the AC Adapter.
Page 241
Page 242
Page 243
Page 244
Page 245
Page 246
Page 247
Page 248
Page 249
Page 250
Page 251
Page 252
Page 253
Page 254
Attachment - General Procedure