2019 Infiniti M35 V6-3.5L (VQ35HR) Diagnostic and Repair Information Page 215
Without CONSULT-III
1. Turn ignition switch OFF.
2. Disconnect MAF sensor harness connector and reconnect it again.
3. Start engine and warm it up to normal operating temperature.
4. Check the voltage between ECM harness connector terminals under the following conditions.
Is the inspection result normal?
YES - INSPECTION END
NO - Clean or replace malfunctioning MAF sensor.
P010D
P0102, P0103, P010C, P010D MAF SENSOR
Description
The mass air flow sensor (1) is placed in the stream of intake air. It measures the intake flow rate by measuring a part of the entire intake flow.
The mass air flow sensor controls the temperature of the hot wire to a certain amount. The heat generated by the hot wire is reduced as the intake
air flows around it. The greater air flow, the greater the heat loss.
Therefore, the electric current supplied to hot wire is changed to maintain the temperature of the hot wire as air flow increases. The
