Steering/Suspension - Wheel Bearing Collision Damage

Infiniti G35x Sedan AWD V6-3.5L (VQ35DE) Technical Service Bulletin # 10-067 Date: 101021

Steering/Suspension - Wheel Bearing Collision Damage

Classification: FA10-007

Reference: ITB10-067

Date: October 21, 2010

WHEEL BEARING COLLISION DAMAGE

APPLIED VEHICLES: All Infiniti

SERVICE INFORMATION

Impacts to wheel bearings (such as a collision or other suspension damage) may create slight indents in the bearing surfaces. These indents may not

be visible but can cause bearing noise.

NOTE:

Hub/bearing replacement due to impact (collision or other suspension damage) is not a warrantable repair.

If a vehicle has visible wheel or suspension damage due to impact (collision or other suspension damage) it is recommended that the wheel bearing

assembly be inspected as follows:

1. Remove the hub/bearing assembly from the vehicle.

2. Hold the hub/bearing assembly with both hands.

3. Rotate the hub/bearing assembly in both directions (clockwise and counterclockwise).

4. If any gritty or rough feeling is detected in the bearing replace it with a new one.

Electrical - Electronic Component Damage Prevention

Disclaimer Infiniti G35x Sedan AWD V6-3.5L (VQ35DE) Technical Service Bulletin # 09-020 Date: 090406

Electrical - Electronic Component Damage Prevention

Classification: EL09-012

Reference: 09-020

366

Date: April 6, 2009

ELECTRONIC CONTROL UNIT DAMAGE CAN RESULT FROM IMPROPER BATTERY CONNECTION

APPLIED VEHICLES:

All Infiniti

SERVICE INFORMATION

^ The vehicle 12 volt battery is an important part of the vehicle electrical system and is required to stay connected when the engine is running.

^ To prevent damage to vehicle electronic components follow the instructions / cautions below.

IMPORTANT:

Damage to electronic components (ECM, TCM, BCM, etc.) due to improper battery connection will not be covered under warranty.

CAUTION:

^ Make sure the ignition is OFF during battery service and replacement.

^ Do not disconnect or connect any battery cables while the ignition switch is turned ON.

^ When disconnecting a battery, always disconnect the negative cable first.

^ When connecting a battery, always connect the positive cable first.

^ Do not leave a battery cable loose. Tighten battery cables immediately after attachment.

^ If a battery cable is loose, do not operate any electrical loads. (This includes turning the ignition ON, starting the engine, operating accessories

such as the A/C system, power seats, interior lights, exterior lights etc.).

^ When "jump starting" or "boosting" a battery - be careful. Don't accidentally reverse the polarity of the cables.