Page 144
Tire Monitor System - Tire Pressure Info.
Classification: WT08-004C
Reference: ITB08-015C
Date: October 3, 2011
TIRE PRESSURE INFORMATION FOR VEHICLES WITH TPMS
The publication data on this bulletin has been amended to include newest models.
APPLIED VEHICLES:
All Infiniti vehicles with Tire Pressure Monitor System (TPMS)
SERVICE INFORMATION
The Low Tire Pressure Warning Lamp will illuminate (steady not flashing) if the tire pressure is low in any of the four road tires.
^ This is not an indication of a malfunction. Rather it is a signal to the driver that the tire pressure in the vehicle must be adjusted.
Tire pressure must be adjusted/corrected at or above the pressure shown on the TIRE AND LOADING INFORMATION label before the Low Tire
Pressure Warning Light will go OFF.
^ Regular tire pressure maintenance such as described in this bulletin is not covered under the warranty.
The air pressure inside a tire can change due to several factors such as:
^ Seasonal temperature change
^ Tire temperature change due to driving
^ Natural pressure loss over time
Compensate for the above temperature factors when adjusting and setting tire pressure.
Each vehicle is equipped from the factory with a TIRE AND LOADING INFORMATION label.
This label lists the COLD tire pressure setting for the original tires on the specific vehicle.
NOTE:
Tires are considered COLD after the vehicle has been parked for 3 or more hours or driven less than 1 mile at moderate speeds.
When setting / adjusting tire pressure, make sure to use an accurate tire pressure gauge.
Use the following information for reference:
Temperature:
^ Tire pressure changes approximately 0.8 psi for every 10��F of temperature change. As temperature decreases, pressure decreases.
^ Tire pressure may change 3 - 5 psi between a Cold reading and a reading taken just after the vehicle has been driven for several miles.
Page 145
^ Seasonal temperature change can result in tire pressure that is low enough to turn on the Low Tire Pressure Warning Light.
Example 1 - Seasonal Temperature Change:
^ The temperature of the vehicle is 70��F after sitting in the shop.
^ Ambient temperature outside the shop is 30��F or will soon fall to 30��F due to seasonal change.
^ Recommended pressure on the TIRE AND LOADING INFORMATION label is 35 psi.
^ The tire pressure should be compensated an additional +3 psi and adjusted to 38 psi to avoid dropping below the label value when the vehicle
experiences cooler ambient air temperature.
^ Compensation should also be used in the PDI process as needed.
Example 2 - WARM Tires:
^ A vehicle arrives to the dealer after being driven across town.
^ The WARM tire pressure reading is 32 psi.
^ Recommended COLD tire pressure on the TIRE AND LOADING INFORMATION label is 35 psi.
^ The tire pressure should be compensated an additional +3 psi and adjusted to 38 psi to avoid dropping below the label value when the tires cool.
Natural tire pressure loss overtime:
^ Vehicle tire pressure can naturally decrease by approximately 1.0 - 1.5 psi per month. This will vary due to seasonal temperature change.
^ After 6 to 8 months tire pressure may be low enough to turn ON the Low Tire Pressure Warning Light.
High Altitude
^ At high altitude locations a standard tire pressure gauge may show the tire pressure higher than the TPMS system. If the gauge reading is not
accounted for this could result in turning ON the Low Tire Pressure Warning Light.
^ Standard tire pressure gauge readings increase about 1.0 psi for every 2,200 ft of altitude increase above sea level (up to 10,000 ft). See Graph 3.
^ For example if the TIRE AND LOADING INFORMATION label reads 33 psi then at an elevation of 5,280 ft, the cold inflation pressure using a
gauge should be increased 2.5 psi to 35.5 psi."
NOTE:
In the above example, C-III, Signal Tech II, or the vehicle information display (if equipped) would show a tire pressure of 33 psi. If needed use
C-III or Signal Tech-II to confirm tire pressure.
NOTE:
Page 146
^ After correcting the tire pressure the vehicle may need to be driven at speeds above 16 mph to activate the TPMS and turn off the low tire pressure
warning light.
^ If pressure compensation for temperature is used, the pressure should be re-checked and adjusted at a later time when the tires are cold.
^ If after turning the ignition ON, the TPMS light flashes for one minute and then turns solid, refer to ITB10-023 or ITB09-050.
INFINITI Diagnostic and Repair Information ,Wiring Diagrams. DTC. TSB. Types: TSB, DTC, Wiring Diagrams, OEM Procedures. Trusted by more than 400,000 technicians. OEM accurate fix for faster repairs. Repair Procedures and Labor Times. Factory Auto Repair info. Request A Demo Today. Factory-Correct Diagrams. Factory Part Numbers. Maintenance Schedules. Repair Procedures. Labor Times. Types: TSB, DTC.