2017 Infiniti G37 Sedan V6-3.7L Diagnostic and Repair Information # 09-011A Date: 120827

Wipers/Washers - Intermittent Wiper Operation Information
Classification: EL09-008A
Reference: ITB09-011A
Date: August 27, 2012
INTERMITTENT WIPER OPERATION
This bulletin has been amended to apply to all vehicles with Intermittent Rain Sensing Wipers.
Page 69
APPLIED VEHICLES:
Infiniti vehicles with Intermittent Rain Sensing Wipers
SERVICE INFORMATION
Vehicle may be equipped with the Rain-Sensing Auto Wiper system.
With this system:
> A rain sensor is located on the windshield, if equipped.
> When the wiper lever is pushed down to the intermittent (INT) position, the wipers will operate when the rain sensor detects rain.
> May only make a single stroke unless rain is detected directly above the sensor.
NOTE:
The wipers may operate unexpectedly when dirt, fingerprints, oil film, or insects are located on or around the sensor, or when exhaust gas or
moisture affect the rain sensor.
EXAMPLES OF RAIN SENSORS
If a customer states the wipers do not work when the wiper lever is pushed down to the intermittent (INT) position, make sure the customer is
familiar with the above information.
^ You can demonstrate the operation of the system by pushing the wiper lever down to the intermittent (INT) position and spraying/sprinkling water
over the rain sensor.
NOTE:
If a wiper-operation incident does occur, refer to the applicable Electronic Service Manual (ESM) for further diagnostic assistance.

2017 Infiniti G37 Sedan V6-3.7L Diagnostic and Repair Information # 12-019 Date: 120417

Body - Paint Chipping Off Edge of Trunk Lid
Classification: BT12-002
Reference: ITB12-019
Date: April 17, 2012
G SEDAN; PAINT CHIPPING OFF EDGE OF TRUNK LID
APPLIED VEHICLES: 2007-2012 G25/G35/G37 Sedan (V36)
APPLIED VINS & DATES
IF YOU CONFIRM
Page 79
Paint chipping Paint is chipping off the edge of the trunk lid in the locations shown in Figure 2. Surface corrosion in this area may also be visible.
ACTION

1. Inspect the trunk lid for proper clearance and latching, and make adjustments if needed.


2. Adjust the bumper rubbers ("stoppers").


3. Confirm the rear combination lamp lens located below the chipped paint is flush/even with the housing.


4. If not flush/even, replace the rear combination lamp assembly.


5. Using standard auto body repair practices, perform a Refinish Half-Block Repair to the area of the trunk lid where paint has chipped off.

IMPORTANT:
The purpose of ACTION (above) is to give you a quick idea of the work you will be performing. You MUST closely follow the entire Service
Procedure as it contains information that is essential to successfully completing this repair.
PARTS INFORMATION
Page 80
CLAIMS INFORMATION
SERVICE PROCEDURE
1.Visually inspect the clearance/gap between the trunk lid and rear fender, rear combination lamp, back up lamp, and rear bumper.
^ If clearance/gap does not appear even, refer to section DLK>Trunk Lid Assembly: Adjustment in the applicable Electronic Service
Manual (ESM) and make adjustments as instructed.
2. Open and close the trunk lid. If abnormal force is required to close the trunk lid, refer to section DLK> Trunk Lid Assembly: Adjustment in
the applicable ESM and adjust the trunk striker and hinge as instructed.
Page 81
3. Open the trunk lid and adjust both bumper rubbers ("stoppers").
a. Unlock the stopper by rotating the lock nut counterclockwise until fully loose. See Figures 5 and 6.
b. Pull the stopper outward until fully extended. DO NOT remove the stopper.
c. Gently lower the trunk lid, increasing pressure slowly until it latches.
d. Open the trunk lid, then hold each stopper in place while rotating the lock nut clockwise until it stops.
4. Confirm the position of the rear combination lamp located below the chipped paint.
Page 82
a. Visually inspect and run your finger along the top of the rear combination lamp lens in the area shown in Figure 9.
b. If the lens is positioned above the rear combination lamp housing (see Figure 10) within the area shown in Figure 9, replace the affected
rear combination lamp assembly.
c. If the lens is flush/even with the housing, proceed to step 5.
5. Using standard auto body repair practices, perform a Refinish Half-Block Repair to the area of the trunk lid where paint has chipped off.