Saturday, February 1, 2020

2019 Infiniti M35 V6-3.5L (VQ35HR) Diagnostic and Repair Information Page 794

2019 Infiniti M35 V6-3.5L (VQ35HR) Diagnostic and Repair Information Page 794



- GO TO 2.



2.CHECK DTC DETECTION



With CONSULT-III



1. Start the engine.



2. Select "BATTERY VOLT", "MANU MODE SW", "GEAR" and "VHCL/S SE-A/T" in "Data Monitor" in "TRANSMISSION".



3. Drive vehicle and maintain the following conditions for 5 seconds or more.



BATTERY VOLT: 9 V or more



MANU MODE SW: ON



GEAR: 2



VHCL/S SE-A/T: 10 km/h (7 MPH) or more



4. Perform "Self Diagnostic Results" in "TRANSMISSION".



With GST



Follow the procedure "With CONSULT-III".



Is "P2731" detected?



YES - Go to See: P Code Charts/P2731.



NO - INSPECTION END



Diagnosis Procedure



1.CHECK INTERMITTENT INCIDENT



See: Testing and Inspection/Initial Inspection and Diagnostic Overview/How to Perform Efficient Diagnosis For an Electrical Incident.



Is the inspection result normal?



YES - Replace A/T assembly. See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Service and Repair/Removal and



Replacement/7AT RE7R01A/Transmission Assembly/Exploded View.



NO - Repair or replace damaged parts.



P2807



P2807 PRESSURE CONTROL SOLENOID G



Description



- The direct clutch solenoid valve is controlled by the TCM in response to signals transmitted from the transmission range switch, output speed



sensor and accelerator pedal position sensor (throttle position sensor).



Gears will then be shifted to the optimum position.



- The direct clutch solenoid valve controls the direct clutch control valve in response to a signal transmitted from the TCM.



DTC Logic



DTC DETECTION LOGIC



DTC CONFIRMATION PROCEDURE



CAUTION:



Always drive vehicle at a safe speed.



1.PRECONDITIONING



If "DTC CONFIRMATION PROCEDURE" is previously conducted, always turn ignition switch OFF and wait at least 10 seconds before



performing the next test.



- GO TO 2.



2.CHECK DTC DETECTION



With CONSULT-III



1. Start the engine.



2. Select "BATTERY VOLT", "MANU MODE SW", "GEAR" and "VHCL/S SE-A/T" in "Data Monitor" in "TRANSMISSION".



3. Drive vehicle and maintain the following conditions for 5 seconds or more.



BATTERY VOLT: 9 V or more



MANU MODE SW: ON



GEAR: 1



VHCL/S SE-A/T: 10 km/h (7 MPH) or more



4. Perform "Self Diagnostic Results" in "TRANSMISSION".



With GST



Follow the procedure "With CONSULT-III".