2019 Infiniti M35 V6-3.5L (VQ35HR) Diagnostic and Repair Information Page 119
Is the inspection result normal?
YES - GO TO 2.
NO - Replace malfunctioning intake valve timing control solenoid valve.
2.CHECK INTAKE VALVE TIMING CONTROL SOLENOID VALVE-II
1. Remove intake valve timing control solenoid valve.
2. Apply 12 V between intake valve timing control solenoid valve terminals 1 and 2, and then interrupt it. Check that the plunger moves as
shown in the figure.
CAUTION:
Never apply 12 V continuously for 5 seconds or more.
Doing so may result in damage to the coil in intake valve timing control solenoid valve.
NOTE:
Always replace O-ring when intake valve timing control solenoid valve is removed.
Is the inspection result normal?
YES - INSPECTION END
NO - Replace malfunctioning intake valve timing control solenoid valve.
P0024
P0014, P0024 EVT CONTROL
DTC Logic
DTC DETECTION LOGIC
NOTE:
- If DTC P0014 or P0024 is displayed with DTC P0078, P0084 first perform trouble diagnosis for DTC
P0078, P0084. See: P Code Charts/P0078.
- If DTC P0014 or P0024 is displayed with DTC P1078, P1084 first perform trouble diagnosis for DTC
P1078, P1084. See: P Code Charts/P1078.
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.
1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON
3. Turn ignition switch OFF and wait at least 10 seconds.
TESTING CONDITION:
Before performing the following procedure, confirm that battery voltage is between 10 V and 16 V at idle.
