2019 Infiniti M35 V6-3.5L (VQ35HR) Diagnostic and Repair Information Page 118
3.CHECK CRANKSHAFT POSITION SENSOR
See: P Code Charts/P0335.
Is the inspection result normal?
YES - GO TO 4.
NO - Replace crankshaft position sensor.
4.CHECK CAMSHAFT POSITION SENSOR
See: P Code Charts/P0340.
Is the inspection result normal?
YES - GO TO 5.
NO - Replace malfunctioning camshaft position sensor.
5.CHECK CAMSHAFT (INTAKE)
Check the following.
- Accumulation of debris on the signal plate of camshaft rear end
- Chipping signal plate of camshaft rear end
Is the inspection result normal?
YES - GO TO 6.
NO - Remove debris and clean the signal plate of camshaft rear end or replace camshaft.
6.CHECK TIMING CHAIN INSTALLATION
Check service records for any recent repairs that may cause timing chain misalignment.
Are there any service records that may cause timing chain misalignment?
YES - Check timing chain installation. See: Engine, Cooling and Exhaust/Engine/Timing Components/Timing Chain/Service and
Repair/Removal and Installation.
NO - GO TO 7.
7.CHECK LUBRICATION CIRCUIT
Perform "Inspection of Camshaft Sprocket (INT) Oil Groove". See: Engine, Cooling and Exhaust/Engine/Camshaft, Lifters and Push
Rods/Camshaft/Service and Repair/Removal and Installation.
Is the inspection result normal?
YES - GO TO 8.
NO - Clean lubrication line.
8.CHECK INTERMITTENT INCIDENT
See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Initial Inspection and Diagnostic Overview/Trouble
Diagnosis For Intermittent Incident/Description.
- INSPECTION END
Component Inspection
1.CHECK INTAKE VALVE TIMING CONTROL SOLENOID VALVE-I
1. Turn ignition switch OFF.
2. Disconnect intake valve timing control solenoid valve harness connector.
3. Check resistance between intake valve timing control solenoid valve terminals as per the following.
