2019 Infiniti M35 V6-3.5L (VQ35HR) Diagnostic and Repair Information Page 76
OK or NG
OK - Check the condition of harness and connector. If it is OK, check the self-diagnosis results using
CONSULT-III again.
NG - GO TO 2.
2.CHECK HARNESS CONTINUITY
1. Turn ignition switch OFF.
2. Disconnect Intelligent Key unit and unified meter and A/C amp. Connector.
3. Check continuity between Intelligent Key unit connector and unified meter and A/C amp. Connector.
4. Check continuity between Intelligent Key unit connector and ground.
OK or NG
OK -
- If the measured value is not waveform but 0V constant, the harness or connector between the using receiving the vehicle speed signal from
unified meter and A/C amp. may be malfunctioning. Check these wirings.
- If the measured value is not waveform but 5V or 12V constant, replace unified meter and A/C etc. NG - Repair or replace harness.
B2558
INTELLIGENT KEY SYSTEM/ENGINE START FUNCTION
