2019 Infiniti M35 V6-3.5L (VQ35HR) Diagnostic and Repair Information Page 366
YES - Repair or replace malfunctioning part.
NO - GO TO 3.
3.CHECK AIR FUEL RATIO (A/F) SENSOR 1 INPUT SIGNAL CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect corresponding A/F sensor 1 harness connector.
3. Disconnect ECM harness connector.
4. Check the continuity between A/F sensor 1 harness connector and ECM harness connector.
5. Check the continuity between A/F sensor 1 harness connector or ECM harness connector and ground.
6. Also check harness for short to power.
Is the inspection result normal?
YES - GO TO 4.
NO - Repair open circuit, short to ground or short to power in harness or connectors.
4.CHECK FUEL PRESSURE
Check fuel pressure. See: Engine, Cooling and Exhaust/Engine/Tune-up and Engine Performance Checks/Fuel Pressure/Testing and Inspection.
Is the inspection result normal?
YES - GO TO 5.
NO - Replace "fuel filter and fuel pump assembly".
5.CHECK MASS AIR FLOW SENSOR
With CONSULT-III
1. Install all removed parts.
2. Check "MASS AIR FLOW" in "DATA MONITOR" mode with CONSULT-III.
For specification, See: Powertrain Management/Computers and Control Systems/Air Temperature Sensor ( Ambient / Intake )/Specifications.
With GST
1. Install all removed parts.
2. Check mass air flow sensor signal in "Service $01" with GST.
For specification, See: Powertrain Management/Computers and Control Systems/Air Temperature Sensor ( Ambient / Intake )/Specifications.
Is the measurement value within the specification?
YES - GO TO 6.
NO - Check connectors for rusted terminals or loose connections in the mass air flow sensor circuit or grounds. See: P Code Charts/P0102.
6.CHECK FUNCTION OF FUEL INJECTOR
With CONSULT-III
1. Start engine.
2. Perform "POWER BALANCE" in "ACTIVE TEST" mode with CONSULT-III.
3. Check that each circuit produces a momentary engine speed drop.
Without CONSULT-III
1. Start engine and let it idle.
