Monday, May 6, 2019

2019 Infiniti M35 V6-3.5L (VQ35HR) Diagnostic and Repair Information Page 251

2019 Infiniti M35 V6-3.5L (VQ35HR) Diagnostic and Repair Information Page 251



NOTE:



Perform the following steps before engine coolant temperature is above 96锟紺 (205锟紽).



2. Turn ignition switch ON.



3. Select "DATA MONITOR" mode with CONSULT-III.



4. Start engine.



5. Hold vehicle speed at more than 70 km/h (43 MPH) for 100 consecutive seconds.



CAUTION:



Always drive vehicle at a safe speed.



6. Check 1st trip DTC.



With GST



Follow the procedure "With CONSULT-III" above.



Is 1st trip DTC detected?



YES - Go to See: P Code Charts/P0127.



NO - INSPECTION END



Diagnosis Procedure



1.CHECK GROUND CONNECTION



1. Turn ignition switch OFF.



2. Check ground connections M16, M70. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Component



Tests and General Diagnostics/Power Supply and Ground Circuit.



Is the inspection result normal?



YES - GO TO 2.



NO - Repair or replace ground connections.



2.CHECK INTAKE AIR TEMPERATURE SENSOR



See: P Code Charts/P0127.



Is the inspection result normal?



YES - GO TO 3.



NO - Replace mass air flow sensor (bank 1) (with intake air temperature sensor).



3.CHECK INTERMITTENT INCIDENT



See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Initial Inspection and Diagnostic Overview/Trouble



Diagnosis For Intermittent Incident/Description.



- INSPECTION END



Component Inspection



1.CHECK INTAKE AIR TEMPERATURE SENSOR



1. Turn ignition switch OFF.



2. Disconnect mass air flow sensor (bank 1) harness connector.



3. Check resistance between mass air flow sensor (bank 1) terminals as per the following.



Is the inspection result normal?



YES - INSPECTION END



NO - Replace mass air flow sensor (with intake air temperature sensor) (bank 1).



P0128



P0128 THERMOSTAT FUNCTION