2019 Infiniti M35 V6-3.5L (VQ35HR) Diagnostic and Repair Information Page 727
Function (METER/M&A)".
Is the inspection result normal?
YES - GO TO 9.
NO - Replace unified meter and A/C amp. See: Instrument Panel, Gauges and Warning Indicators/Service and Repair.
9.CHECK INTERMITTENT INCIDENT
See: Testing and Inspection/Initial Inspection and Diagnostic Overview/How to Perform Efficient Diagnosis For an Electrical Incident.
Is the inspection result normal?
YES - Replace A/T assembly. See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Service and Repair/Removal and
Replacement/7AT RE7R01A/Transmission Assembly/Exploded View.
NO - Repair or replace damaged parts.
Component Inspection (Manual Mode Switch)
1.CHECK MANUAL MODE SWITCH
Check continuity between A/T shift selector connector terminals.
Is the inspection result normal?
YES - INSPECTION END
NO - Repair or replace damaged parts. See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Shifter A/T/Service and
Repair/Removal and Replacement/7AT RE7R01A/Control Device/Exploded View.
P2100
P1290, P2100, P2103 THROTTLE CONTROL MOTOR RELAY
Description
Power supply for the throttle control motor is provided to the ECM via throttle control motor relay. The throttle control motor relay is ON/OFF
controlled by the ECM. When the ignition switch is turned ON, the ECM sends an ON signal to throttle control motor relay and battery voltage is
provided to the ECM. When the ignition switch is turned OFF, the ECM sends an OFF signal to throttle control motor relay and battery voltage is
not provided to the ECM.
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.
1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. Turn ignition switch OFF and wait at least 10 seconds.
TESTING CONDITION:
Before performing the following procedure, confirm that battery voltage is more than 8 V.
Which DTC is detected?
