2019 Infiniti M35 V6-3.5L (VQ35HR) Diagnostic and Repair Information Page 382
3. Check the voltage between EOT sensor harness connector and ground.
Is the inspection result normal?
YES - GO TO 3.
NO - Repair open circuit, short to ground or short to power in harness or connectors.
3.CHECK EOT SENSOR GROUND CIRCUIT FOR OPEN AND SHORT
1. Turn ignition switch OFF.
2. Disconnect ECM harness connector.
3. Check the continuity between EOT sensor harness connector and ECM harness connector.
4. Also check harness for short to ground and short to power.
Is the inspection result normal?
YES - GO TO 4.
NO - Repair open circuit, short to ground or short to power in harness or connectors.
4.CHECK EOT SENSOR
See: P Code Charts/P0197.
Is the inspection result normal?
YES - GO TO 5.
NO - Replace engine oil temperature sensor.
5.CHECK INTERMITTENT INCIDENT
See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Initial Inspection and Diagnostic Overview/Trouble
Diagnosis For Intermittent Incident/Description.
- INSPECTION END
Component Inspection
1.CHECK ENGINE OIL TEMPERATURE SENSOR
1. Turn ignition switch OFF.
2. Disconnect engine oil temperature sensor harness connector.
3. Remove engine oil temperature sensor.
4. Check resistance between engine oil temperature sensor terminals by heating with hot water as shown in the figure.
