Friday, April 5, 2019

2019 Infiniti M35 V6-3.5L (VQ35HR) Diagnostic and Repair Information Page 735

2019 Infiniti M35 V6-3.5L (VQ35HR) Diagnostic and Repair Information Page 735



Is the inspection result normal?



YES - INSPECTION END



NO - GO TO 2.



2.REPLACE ELECTRIC THROTTLE CONTROL ACTUATOR



1. Replace malfunctioning electric throttle control actuator.



2. Go to See: P Code Charts/P1233.



- INSPECTION END



Special Repair Requirement



1.PERFORM THROTTLE VALVE CLOSED POSITION LEARNING



See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Programming and Relearning/Throttle Valve Closed



Position Learning/Special Repair Requirement



- GO TO 2.



2.PERFORM IDLE AIR VOLUME LEARNING



See: Engine, Cooling and Exhaust/Engine/Tune-up and Engine Performance Checks/Idle Speed/Testing and Inspection/Programming and



Relearning/Special Repair Requirement



- END



P2103



P1290, P2100, P2103 THROTTLE CONTROL MOTOR RELAY



Description



Power supply for the throttle control motor is provided to the ECM via throttle control motor relay. The throttle control motor relay is ON/OFF



controlled by the ECM. When the ignition switch is turned ON, the ECM sends an ON signal to throttle control motor relay and battery voltage is



provided to the ECM. When the ignition switch is turned OFF, the ECM sends an OFF signal to throttle control motor relay and battery voltage is



not provided to the ECM.



DTC Logic



DTC DETECTION LOGIC



DTC CONFIRMATION PROCEDURE



1.PRECONDITIONING



If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.



1. Turn ignition switch OFF and wait at least 10 seconds.



2. Turn ignition switch ON.



3. Turn ignition switch OFF and wait at least 10 seconds.



TESTING CONDITION:



Before performing the following procedure, confirm that battery voltage is more than 8 V.



Which DTC is detected?