2019 Infiniti M35 V6-3.5L (VQ35HR) Diagnostic and Repair Information Page 743
2. Remove the intake air duct.
3. Check if foreign matter is caught between the throttle valve (1) and the housing.
Is the inspection result normal?
YES - GO TO 2.
NO - Remove the foreign matter and clean the electric throttle control actuator inside.
2.REPLACE ELECTRIC THROTTLE CONTROL ACTUATOR
1. Replace malfunctioning electric throttle control actuator.
2. Go to See: P Code Charts/P1238.
- INSPECTION END
Special Repair Requirement
1.PERFORM THROTTLE VALVE CLOSED POSITION LEARNING
See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Programming and Relearning/Throttle Valve Closed
Position Learning/Special Repair Requirement
- GO TO 2.
2.PERFORM IDLE AIR VOLUME LEARNING
See: Engine, Cooling and Exhaust/Engine/Tune-up and Engine Performance Checks/Idle Speed/Testing and Inspection/Programming and
Relearning/Special Repair Requirement
- END
P2122
P2122, P2123 APP SENSOR
Description
The accelerator pedal position sensor is installed on the upper end of the accelerator pedal assembly. The sensor detects the accelerator position
and sends a signal to the ECM.
Accelerator pedal position sensor has two sensors. These sensors are a kind of potentiometer which transform the accelerator pedal position into
output voltage, and emit the voltage signal to the ECM.
In addition, these sensors detect the opening and closing speed of the accelerator pedal and sends voltage signals to the ECM. The
ECM judges the current opening angle of the accelerator pedal from these signals and controls the throttle control motor based on these signals.
Idle position of the accelerator pedal is determined by the ECM receiving the signal from the accelerator pedal position sensor. The ECM uses this
signal for engine operations such as fuel cut.
DTC Logic
DTC DETECTION LOGIC
NOTE:
If DTC P2122 or P2123 is displayed with DTC P0643, first perform the trouble diagnosis for DTC P0643. See: P Code Charts/P0643.