Tuesday, August 13, 2019

2019 Infiniti M35 V6-3.5L (VQ35HR) Diagnostic and Repair Information Page 551

2019 Infiniti M35 V6-3.5L (VQ35HR) Diagnostic and Repair Information Page 551



DTC CONFIRMATION PROCEDURE



1.PRECONDITIONING



If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.



1. Turn ignition switch OFF and wait at least 10 seconds.



2. Turn ignition switch ON.



3. Turn ignition switch OFF and wait at least 10 seconds.



- GO TO 2.



2.PERFORM DTC CONFIRMATION PROCEDURE FOR MALFUNCTION A



1. Turn ignition switch ON.



2. Check 1st trip DTC.



Is 1st trip DTC detected?



YES - Go to See: P Code Charts/P0605.



NO - GO TO 3.



3.PERFORM DTC CONFIRMATION PROCEDURE FOR MALFUNCTION B



1. Turn ignition switch ON and wait at least 1 second.



2. Turn ignition switch OFF, wait at least 10 seconds, and then turn it ON.



3. Check 1st trip DTC.



Is 1st trip DTC detected?



YES - Go to See: P Code Charts/P0605.



NO - GO TO 4.



4.PERFORM DTC CONFIRMATION PROCEDURE FOR MALFUNCTION C



1. Turn ignition switch ON and wait at least 1 second.



2. Turn ignition switch OFF, wait at least 10 seconds, and then turn it ON.



3. Repeat step 2 for 32 times.



4. Check 1st trip DTC.



Is 1st trip DTC detected?



YES - Go to See: P Code Charts/P0605.



NO - INSPECTION END



Diagnosis Procedure



1.INSPECTION START



1. Turn ignition switch ON.



2. Erase DTC.



3. Perform DTC Confirmation Procedure.



See See: P Code Charts/P0605.



Is the 1st trip DTC P0605 displayed again?



YES - GO TO 2.



NO - INSPECTION END



2.REPLACE ECM



1. Replace ECM.



2. Go to See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Programming and Relearning/Additional Service



When Replacing Control Unit/Special Repair Requirement.



- INSPECTION END



P0607



P0607 ECM



Description



CAN (Controller Area Network) is a serial communication line for real time application. It is an on-vehicle multiplex communication line with



high data communication speed and excellent error detection ability. Many electronic control units are equipped onto a vehicle, and each control



unit shares information and links with other control units during operation (not independent). In CAN communication, control units are connected



with 2 communication lines (CAN H line, CAN L line) allowing a high rate of information transmission with less wiring.



Each control unit transmits/receives data but selectively reads required data only.



DTC Logic



DTC DETECTION LOGIC



DTC CONFIRMATION PROCEDURE



1.PERFORM DTC CONFIRMATION PROCEDURE



1. Turn ignition switch ON.