2019 Infiniti M35 V6-3.5L (VQ35HR) Diagnostic and Repair Information Page 564
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If "DTC CONFIRMATION PROCEDURE" is previously conducted, always turn ignition switch OFF and wait at least 10 seconds before
performing the next test.
- GO TO 2.
2.CHECK DTC DETECTION
With CONSULT-III
1. Start the engine.
2. Select "ACCELE POSI" and "VHCL/S SE-A/T" in "Data Monitor" in "TRANSMISSION".
3. Shift the selector lever throughout the entire shift position from "P" to "D". (Hold the selector lever at each position for 2 seconds or more)
4. Drive vehicle and maintain the following conditions for 2 seconds or more.
ACCELE POSI: More than 1.0/8
VHCL/S SE-A/T: 10 km/h (7 MPH) or more
5. Perform "Self Diagnostic Results" in "TRANSMISSION".
With GST
Follow the procedure "With CONSULT-III".
Is "P0705" detected?
YES - Go to See: P Code Charts/P0705/7AT RE7R01A.
NO - INSPECTION END
Diagnosis Procedure
1.CHECK INTERMITTENT INCIDENT
See: Testing and Inspection/Initial Inspection and Diagnostic Overview/How to Perform Efficient Diagnosis For an Electrical Incident.
Is the inspection result normal?
YES - Replace A/T assembly. See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Service and Repair/Removal and
Replacement/7AT RE7R01A/Transmission Assembly/Exploded View.
NO - Repair or replace damaged parts.
P0710
P0710 TRANSMISSION FLUID TEMPERATURE SENSOR A
Description
The A/T fluid temperature sensor detects the A/T fluid temperature and transmits a signal to the TCM.
