2019 Infiniti M35 V6-3.5L (VQ35HR) Diagnostic and Repair Information Page 796
DTC CONFIRMATION PROCEDURE
1.DTC ERASE
Erase the DTC memory of ABS actuator and electric unit (control unit) with CONSULT-III.
- GO TO 2.
2.DTC CONFIRMATION
1. Turn ignition switch ON and wait for 2 seconds or more.
2. Perform the self-diagnosis of ABS actuator and electric unit (control unit) with CONSULT-III.
Is the DTC "U0101" detected?
YES - See: U Code Charts/U0101/ACS.
NO - See: Testing and Inspection/Initial Inspection and Diagnostic Overview/How to Perform Efficient Diagnosis For an Electrical Incident.
Diagnosis Procedure
1.PERFORM SELF-DIAGNOSIS OF TCM
Perform self-diagnosis of TCM with CONSULT-III.
Is any DTC detected?
YES - GO TO 2.
NO - GO TO 4.
2.TCM TROUBLE DIAGNOSIS
Perform trouble diagnosis of TCM. See: Diagnostic Trouble Code Descriptions/DTC No. Index/Automatic Transmission (5AT) or See:
Diagnostic Trouble Code Descriptions/DTC Index/TCM (7AT).
- GO TO 3.
3.ERASE DTC
Erase DTC memory of ABS actuator and electric unit (control unit) with self-diagnosis of CONSULT-III.
Is the DTC "U0101" erased?
YES - INSPECTION END
NO - Replace ABS actuator and electric unit (control unit).
4.PROVISIONAL REPLACEMENT OF TCM
Remove TCM. Install a normal TCM.
- GO TO 5.
5.ERASE DTC
Erase DTC memory of ABS actuator and electric unit (control unit) with self-diagnosis of CONSULT-III.
Is the DTC "U0101" erased?
YES - Replace TCM.
NO - Replace ABS actuator and electric unit (control unit).
EC
U0101 CAN COMM CIRCUIT
Description
CAN (Controller Area Network) is a serial communication line for real time application. It is an on-vehicle multiplex communication line with
high data communication speed and excellent error detection ability. Many electronic control units are equipped onto a vehicle, and each control
unit shares information and links with other control units during operation (not independent). In CAN communication, control units are connected
with 2 communication lines (CAN H line, CAN L line) allowing a high rate of information transmission with less wiring.
Each control unit transmits/receives data but selectively reads required data only.
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
1. Turn ignition switch ON and wait at least 3 seconds.
2. Check DTC.
Is DTC detected?
YES - See: U Code Charts/U0101/EC.
