2019 Infiniti M35 V6-3.5L (VQ35HR) Diagnostic and Repair Information Page 708
Diagnosis Procedure
1.CHECK INPUT SIGNALS
With CONSULT-III
1. Start engine.
2. Select "DATA MONITOR" in "TRANSMISSION".
3. Drive vehicle in the "M" position (1GR), and confirm the ON/OFF actuation of "ATF PRES SW 2" and "ON
OFF SOL". See: P Code Charts/P1731.
OK or NG
OK - GO TO 4.
NG - GO TO 2.
2.CHECK TCM POWER SUPPLY AND GROUND CIRCUIT
Check TCM power supply and ground circuit. See: Diagrams/Electrical Diagrams/Transmission Control Systems/5AT RE5R05A/Main Power
Supply and Ground Circuit.
OK or NG
OK - GO TO 3.
NG - Repair or replace damaged parts.
3.DETECT MALFUNCTIONING ITEM
Check A/T assembly harness connector pin terminals for damage or loose connection with harness connector.
OK or NG
OK - Replace the control valve with TCM. See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Valve Body/Service and Repair.
NG - Repair or replace damaged parts.
4.CHECK DTC
Perform See: P Code Charts/P1731.
OK or NG
OK - INSPECTION END
NG - GO TO 2.
P1752
P1752 INPUT CLUTCH SOLENOID
Description
Input clutch solenoid valve is controlled by the TCM in response to signals sent from the transmission range switch, output speed sensor and
accelerator pedal position sensor (throttle position sensor). Gears will then be shifted to the optimum position.
CONSULT-III Reference Value in Data Monitor Mode
On Board Diagnosis Logic
- This is an OBD-II self-diagnostic item.
- Diagnostic trouble code "P1752" with CONSULT-III or 5th judgment flicker without CONSULT-III is detected under the following
conditions.
- When TCM detects an improper voltage drop when it tries to operate the solenoid valve.
- When TCM detects as irregular by comparing target value with monitor value.
Possible Cause
- Harness or connectors
(Solenoid circuit is open or shorted.)
- Input clutch solenoid valve
DTC Confirmation Procedure
CAUTION:
Always drive vehicle at a safe speed.
NOTE:
If "DTC Confirmation Procedure" has been previously performed, always turn ignition switch OFF and wait at least 10 seconds before
performing the next test.
After the repair, perform the following procedure to confirm the malfunction is eliminated.
WITH CONSULT-III
1. Start the engine.
2. Select "DATA MONITOR" in "TRANSMISSION".
3. Drive vehicle and maintain the following conditions for at least 5 consecutive seconds.
