2019 Infiniti M35 V6-3.5L (VQ35HR) Diagnostic and Repair Information Page 353
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.
1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. Turn ignition switch OFF and wait at least 10 seconds.
- GO TO 2.
2.PERFORM DTC CONFIRMATION PROCEDURE-I
1. Clear the mixture ratio self-learning value. See: Powertrain Management/Computers and Control Systems/Testing and
Inspection/Programming and Relearning/Mixture Ratio Self - Learning Value Clear/Special Repair Requirement.
2. Start engine.
Is it difficult to start engine?
YES - GO TO 3.
NO - GO TO 4.
3.RESTART ENGINE
If it is difficult to start engine, the fuel injection system has a malfunction, too.
Crank engine while depressing accelerator pedal.
Does the engine start?
YES - Go to See: P Code Charts/P0172.
NO - Remove spark plugs and check for fouling, etc.
4.PERFORM DTC CONFIRMATION PROCEDURE-II
1. Keep engine idle for at least 5 minutes.
2. Check 1st trip DTC.
Is 1st trip DTC detected?
YES - Go to See: P Code Charts/P0172.
NO - GO TO 5.
5.PERFORM DTC CONFIRMATION PROCEDURE-III
1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. Turn ignition switch OFF and wait at least 10 seconds.
4. Start engine.
5. Maintain the following conditions for at least 10 consecutive minutes. Hold the accelerator pedal as steady as possible.
6. Check 1st trip DTC.
Is 1st trip DTC detected?
YES - Go to See: P Code Charts/P0172.
