2019 Infiniti M35 V6-3.5L (VQ35HR) Diagnostic and Repair Information Page 113
- INSPECTION END
Component Inspection
1.CHECK INTAKE VALVE TIMING CONTROL SOLENOID VALVE-I
1. Turn ignition switch OFF.
2. Disconnect intake valve timing control solenoid valve harness connector.
3. Check resistance between intake valve timing control solenoid valve terminals as per the following.
Is the inspection result normal?
YES - GO TO 2.
NO - Replace malfunctioning intake valve timing control solenoid valve.
2.CHECK INTAKE VALVE TIMING CONTROL SOLENOID VALVE-II
1. Remove intake valve timing control solenoid valve.
2. Apply 12 V between intake valve timing control solenoid valve terminals 1 and 2, and then interrupt it. Check that the plunger moves as
shown in the figure.
CAUTION:
Never apply 12 V continuously for 5 seconds or more.
Doing so may result in damage to the coil in intake valve timing control solenoid valve.
NOTE:
Always replace O-ring when intake valve timing control solenoid valve is removed.
Is the inspection result normal?
YES - INSPECTION END
NO - Replace malfunctioning intake valve timing control solenoid valve.
P0014
P0014, P0024 EVT CONTROL
DTC Logic
DTC DETECTION LOGIC
NOTE:
- If DTC P0014 or P0024 is displayed with DTC P0078, P0084 first perform trouble diagnosis for DTC
P0078, P0084. See: P Code Charts/P0078.
- If DTC P0014 or P0024 is displayed with DTC P1078, P1084 first perform trouble diagnosis for DTC
P1078, P1084. See: P Code Charts/P1078.
