2019 Infiniti M35 V6-3.5L (VQ35HR) Diagnostic and Repair Information Page 804
- GO TO 2.
2.PERFORM SELF-DIAGNOSIS OF LANE CAMERA UNIT
Perform the self-diagnosis of the lane camera unit with CONSULT-III.
Is "U1000" displayed?
YES - See: Powertrain Management/Computers and Control Systems/Information Bus/Testing and Inspection/Initial Inspection and Diagnostic
Overview/CAN Fundamental/Trouble Diagnosis Flow Chart.
NO - See: Testing and Inspection/Initial Inspection and Diagnostic Overview/How to Perform Efficient Diagnosis For an Electrical Incident.
5AT RE5R05A
U1000 CAN COMM CIRCUIT
Description
CAN (Controller Area Network) is a serial communication line for real time application. It is an on-vehicle multiplex communication line with
high data communication speed and excellent malfunction detection ability.
Many electronic control units are equipped onto a vehicle, and each control unit shares information and links with other control units during
operation (not independent). In CAN communication, control units are connected with 2 communication lines (CAN-H line, CAN-L line) allowing
a high rate of information transmission with less wiring. Each control unit transmits/receives data but selectively reads required data only.
On Board Diagnosis Logic
- This is an OBD-II self-diagnostic item.
- Diagnostic trouble code "U1000" with CONSULT-III or 17th judgment flicker without CONSULT-III is detected when TCM cannot
communicate to other control units.
Possible Cause
Harness or connectors
(CAN communication line is open or shorted.)
DTC Confirmation Procedure
NOTE:
If "DTC Confirmation Procedure" has been previously performed, always turn ignition switch OFF and wait at least 10 seconds before
performing the next test.
After the repair, perform the following procedure to confirm the malfunction is eliminated.
WITH CONSULT-III
1. Turn ignition switch ON.
2. Select "SELF-DIAG RESULTS" in "TRANSMISSION".
3. Touch "START"
4. Start engine and wait for at least 6 seconds.
5. If DTC is detected, go to See: U Code Charts/U1000/AT/5AT RE5R05A.
WITH GST
Follow the procedure "WITH CONSULT-III".
Wiring Diagram - AT - CAN
