Infiniti G35x Sedan AWD V6-3.5L (VQ35DE) Technical Service Bulletin # 08-024B Date: 081009
Restraints - SRS Service Precaution
Classification: RS08-005b
Reference: ITB08-024b
Date: October 9, 2008
SRS PRECAUTIONS DURING SERVICE
This bulletin has been amended to apply to all current production models. Please discard all earlier versions.
APPLIED VEHICLES: All Infiniti Models with SRS Systems
SERVICE INFORMATION
Information necessary to service the Supplemental Restraint System (SRS) safely is included in the "RESTRAINTS" section of the Electronic
Service Manual (ESM) for each vehicle.
365
IMPORTANT:
Turn the ignition switch OFF; disconnect both battery terminals; and wait at least 3 minutes before performing any service on the SRS.
Improper maintenance, including incorrect removal and installation of the SRS, can lead to a serious injury or death caused by unintentional
activation of the SRS.
In addition to the cautions and warnings in the ESM, the following provides additional safety precautions:
- Do not use power tools (air or electric) when working near the diagnosis sensor unit (mounted on the vehicle floor) with the ignition switch
ON. For example, when removing or installing a front seat or center console, or when working underneath the vehicle near the diagnosis
sensor unit.
- Use of power tools (air or electric) can vibrate the vehicle floor. If the battery cables are connected and the ignition switch is ON, these
vibrations can be detected by the diagnosis sensor unit and activate the SRS.
- Do not use a hammer (or any similar object) when working near the side air bag (satellite) sensor (mounted on the B-pillar) with the ignition
switch ON. For example, when adjusting the front door striker with a hammer.
- Use of a hammer (or similar object) near the side air bag (satellite) sensor can vibrate the B-pillar. If the battery cables are connected and the
ignition switch is ON, these vibrations can be detected by the diagnosis sensor unit and activate the SRS.Technical Service Bulletin #
08-052 Date: 081215
Keyless Systems - Intelligent Key Registration Caution
Classification: EL08-034
Reference: ITB08-052
Date: December 15, 2008
INFINITI; I-KEY REGISTRATION CAUTION
APPLIED VEHICLES: All Models with Intelligent Key (I-Key)
CAUTION:
Before starting any I-Key registration procedures:
^ # 1: The vehicle battery voltage must be at and remain above 12.4 volts during the procedure.
THEN
^ # 2: The transmission selector lever must be in the Park position for A/T vehicles or in the Neutral position for Manual transmission vehicles.
THEN
^ # 3: "Wiggle" the steering wheel back and forth to make sure the steering lock is not bound-up on the column, and then release the Steering
Lock.
THEN
^ # 4: Proceed with I-Key registration.
If these steps are not followed before I-Key registration is started electronic damage to the Steering Lock may occur. Electronic damage to the
Steering Lock is not covered under warranty if it should occur under these conditions.
